X10 Transceiver Module All House Version TM13U
- Converts radio signals from Remote Controls, Wireless Switches and Wireless Sensors to X-10 Powerline signals over the mains.
- Comes with a built-in Appliance Module (220V, 5A).
- Status reading with CM11 Computer interface
You may also me interested in the trailing lead version of this product Click here for details
The TM13 Transceiver Module is the central receiver necessary when using Remote Controls, Wireless Switches and Wireless Sensors. The TM13 Transceiver converts the signals from these devices to the X-10 Protocol on the mains, so that all X-10 Modules can be controlled via the mains.
The Transceiver Module contains a selector switch for the House Code. The HouseCode of the TM13, the modules and remote controls have to be set to the same letter code to be able to control up to 16 X-10 modules.
Position “P” will transmit all house codes
The built-in Appliance Module can be switched with a command via a wireless controller, such as a Handheld Remote Control, or via the mains using the X-10 protocol. The built-in Appliance Module always responds to Unit Code 1.When the Transceiver Module is combined with the CM11 Computer interface, the TM13 functions as a ‘gateway’ to transmit signals from remote controls and other devices to the CM11.
Using the TM13, any macros stored in the CM11 Computer Interface can be activated using a wireless remote control and all X-10 addresses can be controlled (max. 256 modules).
The Transceiver Module has a plug and switched socket and can be connected without extra wiring.
Reading the status of the TM13 is possible with the use of the CM11 Computer Interface.
Power: 230V +10% -15%, 50Hz
Supply current: <20mA capacitive
#300W/230V for light bulbs
#Low-voltage halogen lamps with a 500W/230V transformer for inductive / capacitive loads
#1200 W/230V for linear loads
RF Receiver Frequency: 433.92MHz
Marmitek X-10 Power Line: 120kHz +/-2kHz, 3.5Vpp
Signal Sensitivity: 15mVpp min., 50mVpp max. at 120kHz
Input Impedance: >180_ (L-N) at f=120kHz
Ambient Temperature: 0°C to 50°C (operating), -20°C to 70°C (storage)
Dimensions: 52x122x33mm (wxhxl excl. plug)
This product is CE approved for use in the EU.
Failed after a couple of days
Posted by Richard Croxall on 4th Sep 2016
Though it worked well for a couple of days, I'm not impressed that it then failed. We had to switch lights on by hand round the house until I put back the old unit (which has been intermittent).
X10 remote works fine
Posted by Ben Bennetts on 11th Jul 2016
This was a replacement for a dead X10 remote controller. The replacement worked as expected. Good product at a reasonable price and delivered on time.