Features
- Install at the circuit breaker/fuse box
for X10 control of branch lighting circuits or appliances rated up to
16A (ideal for air conditioning, heaters, etc).
- Works with an X10 controller and standard latched or momentary action wall switches, including "designer" wall switches.
The
DIN rail switch is an X10 controlled relay. Discreetly installed at the
distribution box, it switches hard-wired circuits with several switches
(e.g. hallway lighting). The internal relay can be tripped either by
external latched or momentary action standard wall switches or by an
X10 controller. It responds to "standard" X10 commands (All-Unit-Off,
On and Off). When the relay is energised, the LED above the slide
switch is illuminated.
Terminal 1
is designed for toggle switches: the relay picks up when phase is
present and releases when there is no voltage at the terminal.
Terminal 2 is designed for pulse contacts: each time phase is applied the relay switches from one state to the other.
This
unit can replace any pulse contact relay that is commonly used for
multi-switched hall and entry lighting. In discrete locations, e.g.
kitchen lighting, you may prefer to install the AD10 in a small
sub-junction box.
Dimensions
Length 88mm, Width 35mm, Height 65mm.
Supply Voltage
Supply voltage: 230V +10%/-15% 50Hz
Supply current: =< 20mA capacitive
Making capacity: 2KW (incandescent lamp), 700W (motors), 3600W (resistive loads)
EMC emission: According to EN50081-1
EMC immunity: According to EN50082-1
Electrical safety: According to EN60950 and EN60065
This product is CE approved for use in the EU.
Signal sensitivity: 15mVpp min 50mVpp max at 120KHz
Input impedance: => 180Ohms (L-N) at 120KHz
Connections: Screw type terminals for phase, neutral, switched phase, control 1 and 2
Ambient temperature: -10ºC to +40ºC (operation); -20ºC to +70ºC (storage)
Click here for the User Guide - 281Kb
|
