Marmitek X10 Micro Module 4 Address Transmitter TWM4

Sorry - This module is currently out of stock, but the TMD4 module does the same thing and is currently in stock:
https://www.uk-automation.co.uk/tmd4-x10-4-way-transmitter-micro-module/

Features

The Marmitek TWM4 MicroModule is an extremely small ((H = 4.6cm x W = 4.6 cm x D = 1.6cm)) X10 Transmitter for 4 addresses with the following features:-

• Suitable for controlling various Marmitek modules with ON, OFF, DIM +, DIM-, All Lights On, All Units Off or All Lights Off commands.
• The TWM4 can also be used for starting programmed macros in, for example, a Marmitek CM15Pro Computer Interface.
• Can be set to send either ON or OFF commands (fixed mode) or to alternate between ON and OFF commands (alternate mode).
• As a dimmer interface adjustable for use with single-pole make-contact pulse switches and pulse switches with 2 make-contacts (if necessary with a zero position, multi-switch).
• Adjustable automatic (two-way communication) status request.
• Adjustable reception of group commands for status updates in alternate mode.
• Invisible installation built-in behind existing switches or wall sockets. The TWM4 works with all makes and types of switches, which means it can be used in every interior and with all installations.
• Quick and easy to install and program.

For further information about Marmitek Micro Modules click on Marmitek comparison table

Specification

• Rated voltage: 230 VAC +/- 10% , 50 Hz
• Current consumption: < 30 mA capacitive
• Signal transmission: > 5 Vpp in 5 Ù at 120 kHz
• Transmission synchronization: 1 pulse burst at 0°/180°
• Signal sensitivity: 25 mVpp...6 Vpp at 120 kHz ± 4 kHz
• Signal/noise ratio: 1,35 : 1
• X-10 Key codes transmitting: ON, OFF, BRIGHT, DIM, All Lights ON, All Lights OFF, All Units OFF, extended
• X-10 Key codes receiving: ON, OFF, BRIGHT, DIM, extended, Status Request
• Cable Connection range: Up to 2.5 mm², tightening torque 0.5 Nm
• Ambient temperature: 0 °C to 35 °C
• Relative humidity: 30 tot 90% (non condensing)
• Dimensions: 46x46x16mm
• Minimal back box depth: 40mm, advice 50mm

How to Install

For complete information on how to connect the Marmitek TWM4 Micromodule and to program it, download the User manual

Click here for the User Manual - 412Kb